
Garage Door Spring Repair
Snapped torsion or extension springs replaced and sized to your door's real weight.
More on Garage Door Spring Repair →
Springs, cables, openers, new doors and tune-ups for a city where one home in three dates from the 1970s and much of the hillside is mapped for wildfire. Call, or send the form for a written price.
It depends on the part. A broken torsion spring sits near the top of a repair bill, rollers and sensors near the bottom. A new opener or a new door is priced separately, and every price comes in writing before work starts.

Six kinds of work, from a snapped spring to a whole new door. Each has its own page with the signs to look for, how the job is done, and the questions people ask most.

Snapped torsion or extension springs replaced and sized to your door's real weight.
More on Garage Door Spring Repair →
Reversing, humming or dead openers traced to sensors, limits, drives or boards.
More on Garage Door Opener Repair →
Snapped cables, doors off their track, worn rollers and bent track put right.
More on Garage Door Cable Repair →
Chain, belt, screw and wall-mount openers with battery backup, set up and tested.
More on Garage Door Opener Installation →
New sectional doors measured on site, with springs, track and seals matched.
More on Garage Door Installation →
Tune-ups, safety tests, and seals fitted to the 1/8 inch ember-gap rule.
More on Garage Door Maintenance →Two things: their age and the hills around them. Census estimates count 48,084 housing units in the city, and about one in three dates from the 1970s, so most garages here have been through several springs and at least one opener. Then there is fire. CAL FIRE's current hazard map puts about 70% of the city's land in the Very High class, and in the hazard zones California's ember rules cap the gap around a garage door at 1/8 inch. Add a Santa Ana wind season that runs from October through February, and the jobs we see most are worn springs, tired openers and seals that no longer close the gap.

Most calls fit one of these six. Each one links to the page that covers it in detail, so you can read up before you call, or call first and read later.
Usually a broken spring. The garage door spring repair page shows how to tell.
A cable off its drum or a roller out of track. See cable and track repair.
Mostly photo eyes, sometimes limits. Start with opener repair.
Required on new openers since 2019. Read about opener installation.
Separating sections or heavy patching. See new door installation.
A worn bottom seal, and an ember risk. Covered under maintenance and seals.
It should be built around the door, not the sale. We check the balance by hand before touching the opener, size springs to the door's real weight, and run the 2-inch reversal test California asks of anyone servicing an opener. Prices come in writing before work starts. When a repair makes more sense than a replacement, you hear that. When your opener can't legally run a new door, you hear that too, before anything is ordered. We work across Thousand Oaks, from Dos Vientos and Rancho Conejo to Lang Ranch and North Ranch, and over the county line into Agoura Hills and Calabasas.

Anything that leaves the door unbalanced or unable to reverse cannot wait; noise and wear usually can, for a while.
Newbury Park, Dos Vientos and Casa Conejo on the west side, Lang Ranch and Wildwood to the north, North Ranch and the Westlake side to the east, then over the county line to Westlake Village, Agoura Hills and Calabasas. Same pricing everywhere we go.